Section 1 – Product Infromation
PAVE TECH, INC.
PO Box 576
Prior Lake, MN 55372
Name: Type 1 Flexible
Class: 55 ORM-D
CASNo.: 108883 Toluene
UN No.: none
Section II – Hazardous Ingredients
Lactol Spirits: 32.4%
Proposition 65: This product contains a chemical which is reported by the State of California to cause birth or reproductive harm.
Section III – Physical Data
VOC: 378 g/L
Boiling Range: 231-250ºF
Weight per Gallon: 7.50#
% Volatile by weight: 42.08%
Section IV – Fire and Explosion Hazard Data
Flash Point: 52ºF
Extinguishing Media: Dry Chemical or Foam
Unusual Fire & Explosion Hazard:
· Closed containers may explode when exposed to extreme heat of fire.
· Vapors may ignite explosively at ambient temperatures.
· Vapors are heavier than air and may travel long distances to source of ignition and flashback.
· May decompose under fire conditions, emitting irritant and/or toxic gasses. Special Firefighting Procedures:
· Water may be used to cool and protect exposed containers.
Section V – Health Hazard Data
Possible Routes of Entry: Inhalation, Skin, Eyes, Ingestion
Effect of Overexposure: Irritation of eyes, skin, respiratory tract. Prolonged inhalation may lead to mucous membrane irritation, fatigue, drowsiness, dizziness, and/or lightheadedness, headache, lack of coordination, nausea. Prolonged or repeated contact can cause dermatitis, deflating, blurred vision, tearing of the eyes, possible vomiting, diarrhea, central nervous system depression, anesthetic effect or narcosis, difficulty breathing, blood abnormalities, corneal injury, liver damage, kidney damage. Reports have associated repeated and prolonged occupational overexposure to solvents with permanent brain and nervous system damage.
First Aid Procedures
Inhalation (Breathing): Move person to well ventilated area. Get emergency medical attention. Administer oxygen or artificial respiration if necessary.
Skin Contact: Flush from skin with water, and then wash thoroughly with soap and water. Remove contaminated clothing. Wash contaminated clothing before reuse.
Eye Contact: Flush affected area with large amounts of water for at least 15 minutes. Get emergency medical attention.
Ingestion (Swallowing): Get emergency medial attention.
Section VI – Reactivity Data
Incompatibility: Oxidizers, acids, bases, amines
Conditions to avoid: Elevated temperatures, contact with oxidizing agent
Hazardous decomposition products: Carbon Monoxide, Carbon Dioxide
Section VII – Spill or Leak Procedures
Release or Spill:
· Eliminate all sources of ignition.
· Ventilate area with explosion-proof equipment
· Small spills may be collected with absorbent materials
· Use non-sparking tools
· Evacuate all unnecessary personnel
· Large spills: Observe step for small spills. Shut off leak if it is safe to do so. Dike and contain spill. Pump to storage or salvage vessels. Use absorbent materials to pick up excess residue. Keep salvage material and rinse with water, cut of sewers or water. Comply with all regulation and pollution control.
· Disposal in accordance with all applicable regulations
· Avoid discharge to natural waters
Section VIII – Special Protection
Control environmental concentrations below applicable standards. Where repertory protection is required, use only NIOSH/MSHA approved respirators.
Ventilation: Provide dilution ventilation or local exhaust to prevent build-up of vapors. Use explosion-proof equipment. Use non-sparking equipment
Personal Protective Equipment: Eye wash, safety shower, safety glasses or goggles, impervious gloves
Section IX – Special Precautions
Handling & Storage: Store below 110ºF. Keep away form heat, sparks, and open flame.
Other Precautions: Use only with adequate ventilation. Do not take internally. Keep out of reach of children. Avoid contact with skin and eyes and breathing vapors. Wash hands thoroughly after handling, especially before eating or smoking. Keep containers tightly closed and upright when not in use. Empty containers may contain hazardous residue.