How to Use: The Wedgie Mark
- Works well for most Retaining Wall Caps
- Reduces the amount of cutting compared to marking every paver
- More aesthetically pleasing compared to marking one side of every paver
Designed to mark for cutting the “soldier” course on both inside and outside curves.
When cutting the “soldier” course pavers, mark both sides of every other paver. First, lay in 3 full pavers and adjust so that the pavers are perpendicular to the edging and that the gaps are even on both sides of the paver to be marked.
Line up the inside of the “L” with the first corner and mark; then move to the other corner and mark. Next, place the Wedgie Mark on the top of the paver to be marked. There are 2 pins that are attached to the bottom; these go against the sides of the pavers on the outside of the radius.
When both sides are marked, remove the paver and cut. If marked and cut properly, the cuts on both sides should end about a half inch from the end of the paver on the outside of the radius. This leaves a full paver width on all the paver on the outside of all radiuses and again is more aesthetically pleasing. To continue marking, lay in 2 more full pavers and repeat the steps above always marking both sides of every other paver.
Part Number: 4000010
Weight: 1.5 lbs (.68 kg.)